Floriani Fusible Bold Tearaway
Floriani Fusible Bold Tearaway is used to support large or dense embroidery on woven fabrics such as cotton, duck cloth, twill, denim or towels. One layer will support approximately 12,000 embroidery stitches. Use this fusible version to prevent stretching during hooped embroidery. The added fusible prevents the fabric from shifting while embroidering, resulting in perfect outline stitches.
Floriani Fusible Bold Tearaway features a multi-directional tear capability, easily pulling away clean from the embroidery design for a crisp look on the front and back. Also available in a non-fusible version.
To use Floriani Fusible Bold Tearaway:
1. Fuse one layer of the stabilizer to the back of the fabric/item. Be sure to use a piece at least one inch larger than the outer perimeter of the hoop to insure proper stabilization.
*Important – Use a low temp (Silk Setting) iron setting. Do NOT touch the surface of the iron to the fusible coating, press from the fabric side or use a press cloth
(muslin or cotton).
2. Hoop the stabilized fabric.
3. Embroider the design.
4. Remove the hoop from the machine and from the garment.
5. Tear away as much of the stabilizer as possible. It may be necessary to re-heat the stabilizer to have it release from the fabric.
**NOTE: All irons heat differently. The iron temperature given above is a starting point. If you find that you are not getting a good fuse, slowly increase your iron temperature until you achieve a good bond between the fabric and stabilizer.
FFBT-15 (15” X 10 YARDS)