Use this super-light, sticky tearaway
in your ink jet printer to print off hoop/design templates
from your embroidery software. After the template is printed,
remove the protective release paper and stick it on to
the garment or home dec item for perfect embroidery placement!
Floriani's Template Tearaway makes multi-hoop designs
a snap to embroider. Manipulate embroidery designs by
rotating and combining them to make one large design.
With Floriani's Template Tearaway you can achieve precise
placement faster and easier! Make templates for all your
designs! 25 ready to use 8 ½" x 11" sheets.
To use:
- Load one sheet of Template Tearaway in your printer's
paper tray.
- Print the design template from your embroidery software.
This should include cross hairs to aid in alignment.
- Trim the template tearaway if desired to the outer
perimeter of the printed design. (Most software has
the option to print a square around the design to
show the outer most stitching points)
- Peel back the release paper to expose the sticky
surface.
- Stick the template tearaway to the fabric in the
desired position, re-position if needed. Follow the
directions below for hooping your fabric.
Option 1 for setting up the fabric to be hooped (Marks
on Fabric):
-
Pierce the printed "cross-hairs"
running through the design using a water soluble or
air erase pen or pencil. This will make small dots
on the fabric.
-
Remove the template tearaway and
re-adhere it to the release paper for later use.
-
Connect the dots drawn on the fabric
to form a plus sign on the fabric.
-
Using the lines as a guide, hoop
the fabric. Be sure to align the lines on the fabric
with the lines on the inner hoop of your embroidery
frame.
-
Embroider! Perfect hooping could
never be easier!
Option 2 for setting up the fabric to be hooped (No
Marks on Fabric):
-
Lay the inner part of the embroidery
frame on the surface of the item to be embroidered.
(The Template Tearaway will be inside the frame stuck
to the garment.)
-
Align the cross hairs on the Template
Tearaway with the lines on the embroidery hoop as
closely as possible.
-
Hoop the garment/item. *Tip - Use
a few pieces of Wonder Tape by Collins on the underside
of your embroidery frame to keep it from shifting
while you hoop!
-
Lower your needle by turning the handwheel
to make sure the design is aligned in the center.
If you were off, simply use your machines centering
feature to move the design until the needle drops
in the center of the Template Tearaways center cross
hair lines.
